Pool Fence Installation in Edmond, OK

If you are putting in a pool in Edmond, the fence is not an accessory — it is a legal requirement with its own inspection. City code (EMC 16.06.535) requires every pool to be fully enclosed by a barrier at least 4 feet tall whose openings reject a 4-inch sphere, and the city's pool barrier checklist, based on the 2015 ISPSC, turns that requirement into a list of exact measurements an inspector walks with a tape. We build ornamental aluminum and wrought iron pool fences to that checklist, and we support you through the inspection that stands between the finished pool and the first swim.

Open metal is the standard pool-barrier material for a reason: it meets the code's geometry naturally, sheds Oklahoma wind, and keeps sight lines to the water — you can see a child near the pool through an ornamental fence, and you cannot through a privacy panel.

The checklist is specific, and every number is pass-fail. Barrier height: at least 48 inches, measured on the outside of the fence. Ground clearance: no more than a 2-inch gap at grade, or 4 inches where the barrier mounts on the pool structure itself. Openings: nothing that passes a 4-inch sphere, anywhere. Member spacing: if horizontal members sit less than 45 inches apart, they must face the pool side, with vertical spacing under 1.75 inches — the rule that keeps a fence from working as a ladder. Even chain link is addressed, with mesh capped at 2.25 inches square unless slats tighten the openings to 1.75 inches or less. We design the panel spec to these numbers before anything is ordered, because a barrier is not a place to discover a spacing problem after installation.

Pool gates carry the strictest hardware spec on any residential fence. They must open away from the pool, self-close, and self-latch, with the latch release at least 54 inches above the bottom of the gate — or, if the release sits on the pool side, placed at least 3 inches below the top of the gate with no opening larger than half an inch within 18 inches of it. These details are exactly where barriers fail inspection: a gate that latches but does not reliably self-close, or a release mounted at adult-convenient height, sends the whole project back for re-inspection. We spec the hinges and latches to the checklist and adjust them on-site until the gate operates correctly every single time.

The barrier rule is triggered by water deeper than 24 inches, which pulls in hot tubs, spas, and aboveground pools — not just in-ground construction. If a wall of your house forms part of the enclosure, the doors in that wall need alarms, or the pool needs a power safety cover meeting ASTM 1346. And the timing is not optional: the barrier must pass final inspection before the pool is occupied, and using it early draws fines of up to $200 per day, with each day counted as a separate offense. We schedule the barrier build against your pool contractor's timeline so the fence is never the thing holding up the water.

Here is the honest part: if your backyard is already fully enclosed by a fence that meets the checklist, you may need far less than a full pool fence — sometimes only gate hardware upgrades, a latch relocation, or a gap fix at grade. We assess the existing enclosure against the checklist first and quote only what compliance actually requires. Plenty of pool-fence consultations end with a small hardware job instead of a new fence, and we count that as a good outcome.