Driveway Gate Installation in Edmond, OK

A driveway gate is the biggest moving part a fence will ever have, and it works a harder shift than any walk gate: opened daily, pushed by wind, hung on posts that Oklahoma clay tries to move a little every season. Getting one right is mostly decided before anything is fabricated — configuration, opening width, and post engineering, in that order.

We build manual driveway gates ready for daily use, and design them so automation can be added later without redoing the posts.

A single swing leaf is the simple answer for narrower openings. Double drive gates — two leaves meeting in the middle — cover roughly 8–12 feet, the standard span for vehicle, trailer, and mower access, and split the wind load and post burden between two leaves. Sliding gates suit the two situations swing cannot serve: short driveway approaches with no room for a swing arc, and wind-exposed sites where a wide swing leaf stresses hinges and posts and can move uncontrollably if hardware fails. We recommend a configuration at the on-site estimate, because the right answer is written on your driveway, not in a catalog.

In the OKC area, a double drive gate adds about $800–$1,500 to a fence project, with single gates spanning roughly $300–$1,500 depending on material, width, and hardware. It is a meaningful line on a short-run project — and the worst place in the budget to economize, because the gate is the component you touch every day and the first to advertise a cheap build. Post engineering is where the money earns its keep: each leaf hangs on a gate-spec post, set deeper and wider than anything else on the line — the same extra-reinforcement rule Oklahoma guidance applies to corner and end posts — because clay movement shows up at the latch before it shows up anywhere else.

Automating a driveway gate adds motors, control boards, safety sensors, and a power supply — work that warrants professional installation, and electrical permitting where required. Where no power runs near the entry, solar operators are workable only if properly sized and sited, which we assess rather than assume. We quote automation case-by-case on-site instead of off a price sheet, because approach, slope, power access, and gate weight change the answer property by property. If automation is even a maybe, we plan post placement and the power path during the manual build — conduit is cheap while the holes are open and expensive after concrete.

If the entry gets used a few times a week, budget spent on automation is usually better spent on heavier posts and better hinges. A wide swing configuration on a short approach or an exposed, windy site is the wrong geometry no matter how good the hardware — that is slide territory. And on shared entries in HOA neighborhoods, covenants may govern gate styles, colors, and automated equipment, so approval comes before fabrication, not after.